Sideros Engineering Robotic Weld Cell, Fanuc M-710iC/12L Robot with R-30iB controller w/ Fronius TPSi 400 2018 – Low Hours

M-710iC/12L Robot with R-30iB controller

-Dimensions: 16′ x 16′
– Through-arm configuration
– 6axis arm
– 12k payload, 122.0” reach
– 440-575VAC (±10%), 50/60Hz, 3 Phase, 30A Service
– Fanuc R-30iB Robot Controller
– Arctool Software
– ANSI/RIA Compliant Mechanical Unit/Controller

System Positioner
– A8 Single Motor with head and tailstock
– Modular headstock positioners with Fanuc alpha 30/3000iF servo motors and encoders, with RV gear
– reducers and 15″ faceplates.
– Alpha 8 4000iF motor with brake, straight shaft and keyway

Positioner characteristics:

-45,000 in*lb. workload torque
-19 rpm maximum rotational speed
+/- 1,180 degrees default rotational range
-6000 lb. nominal supported load capacity

Fronius TPSi 400 Robotic Welding Package (in place of Lincoln and Binzel equipment)

– TransPuls Synergic 4000 MV MIG inverter-power source
– Fronius Software
– Wire feeder with drive rolls
– Water cooler and flow switch
– Robotica Torch and Drive system
– Robot I/F Kit
– Cable setup for cables from robot controller to power supply
– Hose Pack
– Bracket for wire feeder
– Gas flow sensor
– Ground cable from positioner to power supply
– Process stop package

AD1312-84 Single Robot/Power Source Power Disconnect Panel:

480V, 3-phase, 100A disconnect panel capable of supplying up to 1 robot and 1 power source.

– Constructed per NFPA-70 (NEC) Article 409
– Lockout/Tagout (LOTO) ready

Welding Tables (2)

-System 28 3000x1500mm Siegmund Welding Table with Plasma Nitration