312-761-9396 | Se Habla Espanol

 

Awaiting product image
917997496

1999 Okuma MX-45 VAE Vertical Machining Center โ€“ Video Available

$1,500.00

Awaiting product image

This specific product is no longer available, however we may have other similar or identical products in stock. Please utilize our search function at the top of the page to check and confirm, or fill out the form below:

Video available

Has spindle issue โ€“ Will not go over 500 RPM

It cannot make a tool change due to the drawbar not working from sitting idle. The tool changer works fine.

The draw bar was working fine before we stopped using machine. The spindle bearings are the only problems we know of.

TABLE SIZE โ€”โ€”โ€”- ( WORKING AREA ) โ€”- 20โ€ณ X 40โ€ณ
TRAVEL โ€”โ€”โ€”โ€”โ€“ ( X AXIS ) โ€”โ€”โ€”- 30โ€ณ
TRAVEL โ€”โ€”โ€”โ€”โ€“ ( Y AXIS ) โ€”โ€”โ€”- 18.1โ€ณ
TRAVEL โ€”โ€”โ€”โ€”โ€“ ( Z AXIS ) โ€”โ€”โ€”- 17.7โ€ณ
SPINDLE END TO TABLE SURFACE โ€”โ€”โ€”โ€”โ€“ 6.3โ€ณ TO 24โ€ณ
SPINDLE SPEED RANGE โ€”โ€”โ€”โ€”โ€”โ€”โ€”โ€“ 50 TO 7000 RPM
SPINDLE TAPER โ€”โ€”โ€”โ€”โ€”โ€”โ€”โ€”โ€”โ€“ CAT #40
RAPID TRAVERSE RATE โ€“ ( X & Y AXIS ) โ€”โ€” 1181 IPM
RAPID TRAVERSE RATE โ€“ ( Z AXIS ) โ€”โ€”โ€”- 645 IPM
CUTTING FEED RATE โ€”โ€”โ€”โ€”โ€”โ€”โ€”โ€”- 394 IPM
TOOL MAGAZINE CAPACITY โ€”โ€”โ€”โ€”โ€”โ€”โ€“ 20
SPINDLE DRIVE MOTOR โ€“ ( 30 MIN./CONT.) โ€”- 10/7.5 HP
EQUIPPED WITH โ€”

OSP 700M CNC CONTROL
FULL ENCLOSURE
20 STATION TOOL CHANGER
COOLANT SYSTEM
AUTOMATIC LUBRICATION
MANUAL PULSE GENERATOR

WEIGHT: 12125 LBS.
DIMENSIONS (IN.): 89 X 68 X 98